BUET ILS
BUET Institutional Repository: Home
→
Dissertation/Theses
→
Dissertation/Theses - Department of Materials & Metallurgical Engineering
→
Browsing Dissertation/Theses - Department of Materials & Metallurgical Engineering by Author

Browsing Dissertation/Theses - Department of Materials & Metallurgical Engineering by Author "Kurny, Dr. ASW"

Now showing items 1-7 of 7

Characterisation and beneficiation of Narsingdi clay

Ummul Khair Sultana (Department of Materials and Metallurgical Engineering (MME), 2012-05)

A sample of clay was collected from Narsingdi, near Dhaka for the purpose of this study. The sample of clay was characterized by its moisture content, bulk density, organic matter content, pH, alkalinity, liquid limit, ...
Characterisation and recovery of metal values from spent lithium-ion batteries

Al Hossaini Shuva, Mohammad (Department of Materials and Metallurgical Engineering, 2013-01)

Lithium ion batteries were characterized to identify the potential of recovering metal values from these batteries. Different component parts of spent batteries of two types (M 660 and V83) were examined. The outer casings ...
Effects of copper and nickel on the structure and properties of heat treated AI-6Si-0.5Mg alloy

Abul Hossain (Department of Materials and Metallurgical Engineering (MME), 2014-05)

The purpose of this research was to investigate the influence of copper and nickel on Al-6Si- 0.5Mg alloy. Copper in the range of 0.5 - 4 wt%, individual nickel 2wt% and combined 2wt%Cu and 2wt% Ni have been added to ...
Effects of inclusions on the quality of steel

Abul Hossain (Department of Materials and Metallurgical Engineering (MME), 3009-06)

Mini steel of mills or plants in Bangladesh melt scraps in Induction Furnaces. Very little refining the liquid steels is possible in these induction furnaces. In many plants the molten steels are cast into what are usually ...
Effects of scrap addition on the physico-chemical properties of rigid polyvinyl chloride products

Jalal Uddin, Md. (Department of Materials and Metallurgical Engineering (MME), 2014-01)

Raw material powder mixtures have been prepared with polyvinylchloride (PVC) resin, unplasticized polyvinylchloride (uPVC) scraps and additives by melt mixing method. A twin screw extruder has been used to make pipe for ...
Investigation into physical and mechanical properties and failure mode of resistance spot welded dissimilar metal joints

Rysul Alam Shawon, Md. (Department of Materials and Metallurgical Engineering (MME), 2014-03)

Resistance spot welding is a widely used technique for fabricating sheet metal assemblies because of its high speed, efficiency, reduced cost and suitability for automation. The objective of this thesis was to study the ...
Recovery of Zinc from ash of galvanizing plant by hydrometallurgical route

Shah Najiba (Department of Materials and Metallurgical Engineering (MME), 2010-01)

Zinc ash is a discarded material of galvanizing plant and consists mostly of oxidized zinc that forms on the surface of molten zinc metal in galvanizing pot. The ash is removed from the top of galvanizing baths by skimming ...

Now showing items 1-7 of 7

Search BUET IR

Advanced Search

Browse

All of IR
This Collection

Browsing Dissertation/Theses - Department of Materials & Metallurgical Engineering by Author "Kurny, Dr. ASW"

Browsing Dissertation/Theses - Department of Materials & Metallurgical Engineering by Author "Kurny, Dr. ASW"

Search BUET IR

Browse

All of IR

This Collection

My Account