In this thesis, the modified sol-gel route for the synthesis of CuO-based nanoparticles (NPs) was optimized and pristine, p-block element fluorine (F) doped and rare earth element gadolinium (Gd) along with F co-doped CuO ...

The phosphorus (P) content in carbon steel is generally kept below 0.05 percent. This small quantity tends to dissolve in ferrite, increase the strength and hardness slightly. In larger quantities, phosphorous reduces ...

In this thesis, pristine, p-block element nitrogen (N) doped, and rare earth element erbium (Er) co-doped ZnO nanoparticles (NPs) were successfully prepared using chemical co-precipitation technique. Synthesized pure, ...

In this study, pristine and rare-earth elements doped ZnO nanoparticles were successfullysynthesized as potential photocatalystsby modified sol-gel method. Synthesized nanoparticles were characterized usingX-ray diffraction, ...

High strength Al–Zn–Mg–Cu alloys (7xxx series aluminium alloys) have been widely used in military and aerospace industries due to high strength, easy formability and low density. Other important properties that must be ...

Textile is one of the fastest growing industries in Bangladesh. Textile dyeing industry consumes large quantities of water and produces large volumes of wastewater from different steps in the dyeing and finishing processes. ...

In this study an attempt was taken to experiment and compare conventional co-doping and novel compositionally-complex ceramics (CCCs) concept in multiferroic bismuth ferrite (BiFeO3). Both co-doped BiFeO3(BBFMO; 〖Bi〗_0.8 ...

For the last 50 years, plastics are being widely used all over the world starting from drinking cups and disposable silverware to parts for automobiles and motorcycles. These materials have brought a lot of convenience and ...

Growing polymer consumption, depletion of metallic resources, and rising environmental concerns have resulted in an increased interest in bio-derived environment friendly polymeric composite materials. The utilization of ...

BiFeO3 (BFO) Ferrite ceramics were synthesized by an improved solid-state technique in conjunction with high-energy ball milling. Calcination was carried out at 800°C for 2 hours at a heating rate 5 °C/min and cooling rate ...