Abstract:
The research aimed at optimizing the composition and sintering parameters of Ta2O5 doped
BaTiO
3 ceramics to enhance its dielectric properties. For conducting the research, BaTiO3 was
dopedwith Ta2O5 in the range of 0.5-1.5 mole %.
At first, nano sized pure BaTiO3 and Ta2O5 were milled, dried and pressed into pellets to
prepare the green samples. Then the green samples were fired in a high temperature furnace
for densification. Both single and double stage sintering was used for densification of the
samples. Thereafter SEM and XRD techniques were used to examine the structure of the
sintered samples with particular focus on the incorporation of Ta5+ ions into the BaTiO3crystal
lattice. During XRD analysis, the X-ray diffraction peaks of (111), (200) and (002) planes of
BaTiO
3 and (220) plane of Ta2O5 were investigated. The SEM analysis was focused on
measuring grain size andinvestigating grain size distribution of the sintered samples.
Following the SEM analysis, EDX analysis was conducted for elemental analysis and to
understand the diffusion process of Ta5+ in the BaTiO3crystallattice. Finally, dielectric
properties of the samples were measured using an impedance analyzer. Finally, a correlation
was established between the dielectric properties of the sintered samples and their
microstructure.
From the research, it can be concluded that single stage sintering in the range of 12500C to
13000C for 2hrs proved insufficient for diffusion of Ta5+ ion into the lattice. As a result, Ta2O5
gave strong pinning effect and resulted in poor dielectric properties of doped BaTiO3
ceramics. However, double stage sintering proved to be effective for diffusion of Ta5+ ion into
the latticeand enhancing the dielectric properties of Ta2O5 doped BaTiO3 ceramics. The best
room temperature dielectric constant of 22,000-23,000 was obtained for 1.5 mole% Ta2O5
doped BaTiO3 sintered at 13100C for zero hours and 12800C for six hours. Such high dielectric
constant was achieved due to the combination of high %theoretical density and optimum
grain size at this sintering condition.At a temperature range of 300 to 600C, this combination
of composition and sintering parameters yielded dielectric constant of around 21,000.In
addition to enhancing dielectric constant, 1.0-1.5 mole % Ta2O5 stabilized the cubic phase of
BaTiO
3. However, at certain sintering condition, even 0.5mole% Ta2O5 stabilized the cubic
phase of BaTiO3.
